How to Install a Fish Finder on a Boat

If you have purchased a fish finder for your boat but have no clue how to install it you have come to the right place! Today we are going to learn how to install a fish finder on a boat the simple and easy way. So if you are struggling with your fish finder please pay close attention to the helpful information below.

Installing the Binnacle Mount

The first step in the how to install a fish finder on a boat process begins with finding the right spot for the binnacle mount. The binnacle mount will be used to hold your fish finder display in place. Look for a location that is close to the helm of the boat. This will allow you to have easy access to your display which will make fishing more enjoyable. Once you have located the perfect spot for the binnacle mount, you will need to drill some holes for the mounting bolts. Before drilling any holes make sure that there are no wires or obstructions under the area that you will be drilling in. Next, you will need to line up your binnacle mount and use a marker to outline the location you will be drilling in. After you have drilled the holes mount the binnacle with the bolts that were provided. Once you have it properly mounted you should use some clear silicone to seal up the area of the mount. This will prevent any water from getting into the hull of your boat.

Running the Power Wires

After you have gotten the binnacle mount in place you will need to supply power to the display unit. To do so you will need to drill an additional hole for the wires to exit and make their way to the battery.

Once you have the proper sized hole drilled you will need to feed your power wires into the hull of the boat. Carefully pull them to the location of your battery and install them according to the manufacturer's instructions. You will notice that there is an inline fuse located near the end of the power wires. This fuse should not be removed and is there to protect your fish finder from power surges. Removing it could potentially void any warranty that may have come with the fish finder. After you have properly installed the wiring make sure the seal up exit hole with the rubber washer provided. You may also use some clear silicone to help prevent any leakage.

Installing the Transducer

Last but not least you will need to install the transducer. The transducer should be mounted on the bottom of the boat. When choosing your transducer location make sure to pick an area that is within reach of your wiring. Also, pick an area of the hull that is flat and strong. Most fish finders will come with a waterproof adhesive that will make mounting the transducer a breeze! Before mounting make sure the area is clean so the adhesive will stick properly.

In Conclusion

Now that you know how to install a fish finder on a boat why not get the job done today? Once you have your fish finder mounted it will make fishing more fun!

Sharing is caring!

Leave a Reply

Scroll to Top
%d bloggers like this: